Vehicle category · AGRI & GRONDVERZET Verlichting
Agri and earth-moving lighting — tractors, dumpers, loaders.
Agricultural tractors, articulated dumpers, wheeled loaders, dozers, excavators and the wider earth-moving fleet face working conditions that no other vehicle category sees: 18-hour shifts under floodlight in autumn, dust storms on quarry roads in summer, sub-zero starts in winter. Lighting on these machines is a productivity tool, not a compliance afterthought.
Laatst bijgewerkt 24 april 2026
Why agri / construction lighting is different
Three things separate this category from on-road work:
**Vibration.** A wheeled loader takes more vibration in an hour of work than a long-haul tractor takes in a week. Lamps need MIL-STD-810G or equivalent — the budget-end LEDs without proper potting will fail mechanically inside a season.
**Dust and washing.** Dry dust in a quarry, wet mud at a road-build, jet-washing every weekend. IP69K is the minimum spec; IP67 lamps will survive but with shorter service life.
**Working hours.** A combine harvester runs 18 hours a day during harvest. A 50,000-hour LED rated for 8-hour duty cycles fails at 8,000–12,000 hours of continuous use. Buy lamps with full-duty-cycle specs declared.
Tractor and combine lighting
Modern tractors leave the factory with comprehensive LED lighting on the cab roof, A-pillars and front grille — but agricultural operators routinely add more for harvest and ploughing.
Common retrofits:
- **Roof-front bar** facing forward at the work area - **Roof-rear flood** for trailer hitching at night - **A-pillar pencil-beam** for distant-row alignment in low-headlight ploughs - **Side-cab work-light cluster** for adjacent-row lighting during harvest - **Cab-wing flood** lighting the wheel paths during grain-cart unloading
A typical "harvest ready" upgrade adds 8–12 LED lamps totalling around 800W. The tractor's alternator handles it without modification on most modern builds.
Earth-moving and quarry equipment
Wheeled loaders, articulated dump trucks, motor graders and excavators all share a common lighting profile: heavy work-light cluster front and back, amber R65 beacon mandatory on most public-quarry sites, and a rotating-beacon-style strobe option for active loading-and-tipping zones.
Quarry sites often impose their own lighting standards — frequently stricter than ECE — including dual amber beacons (one front, one rear), reflective tape patterns down the body sides, and strobe-pattern stop lamps that stay on for 5 seconds after the brake is released. Check site rules before fitting.
A combine that breaks down at 02:00 on the last night of harvest costs more than the entire fleet's lighting upgrade. Lamps that work all night, every night, are not optional.
Voltage on agri equipment
Most modern tractors run 12V; modern earth-movers run 24V; a few hybrid agricultural machines run dual-voltage. As always: check the spec label before fitting.
Agricultural-spec lamps from us are 9–33V wide-input and don't care about the voltage. Cheaper lamps may not be — and will let go on a load-dump event the way they would on any heavy diesel platform.